Procedure - HP StorageWorks NAS b2000 v2 Quick Start Manual

Plankton_book.book Page 31 Monday, February 3, 2003 4:06 PM

Procedure

NAS b2000 v2 Quick Start Guide
All manuals and user guides at all-guides.com
To initialize the NAS b2000 v2 using the WebUI configuration application:
Caution: Do not power up the NAS device until steps 1 through 5 are
completed.
1. Connect the Ethernet cables to the respective network ports of the
NAS b2000 v2 and the corresponding network segments, in accordance with
the information in the "Configuration Information" section in Chapter 2.
2. See Figure 5and Table 4
NAS b2000 v2.
3. Verify that the Windows-based PC client is connected to the same subnet as
the NAS b2000 v2.
4. Power on the Windows-based PC and wait until the operating system has
completely loaded.
5. Insert the RapidLaunch CD into the DVD-ROM drive.
6. The RapidLaunch CD should automatically run. If the program does not start
up automatically, the program may be run manually. Click Start, then select
Run on the Windows taskbar, and then type the following:
{CD ROM drive}:\setup.exe
Wait for the interface to start up.
7. Go to the NAS device and power it on. It will be several minutes before the
NAS device is accessible on the network.
8. Return to the Windows-based PC. Select HP StorageWorks NAS from the
Show drop down list to have RapidLaunch list all NAS devices on the
network, as shown in
for the locations of the network ports on the
Figure 6.
Configuration Setup
31