Figure 10: Serial number location
Requirements
The following items are required to run the WebUI configuration application:
■
■
■
Note:
and mouse. These ports are available and supported by the NAS device, if used.
Procedure
To initialize the NAS b2000 v2 using the WebUI configuration application:
1. Connect the Ethernet cables to the respective network ports of the
2. See
NAS b2000 v2 Quick Start Guide
Windows-based PC loaded with Internet Explorer 5.5 (or later) on the same
segment as the NAS b2000 v2
DHCP-serviced network
Serial number of the NAS b2000 v2
The NAS b2000 v2 is designed to be deployed without a monitor, keyboard,
NAS b2000 v2 and the corresponding network segments in accordance with
the information in the "Configuration Information" section in Chapter 2.
Figure 5
and
Table 4
NAS b2000 v2.
for the locations of the network ports on the
Configuration Setup
37