Image 10.6 Owner's Manual page 19

e.Error c ode
"E5" may appear in the PULSE display if a pulse error occurs. See HOW TO USE THE PULSE
SENSOR on pages 6 and 7, and HOW TO USE THE PULSE MODE on page 10.
4. SYMPTOM: THE PULSE SENSOR DOES NOT FUNCTION PROPERLY
a. See HOW TO USE THE PULSE SENSOR on page 7.
5. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. If an extensioncord is needed, use onlya 14-gauge general-purpose cord of fivefeet or less in length
b. If the walking belt still slows when walked on, please call our toll-free HELPLINE.
6. SYMPTOM" THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the belt tool, turn the rear
roller adjustment bolt clockwise 1/4 of a turn. Plug in the power
cord, insert the key and nJn the treadmill for a few minutes.
Repeat untdthe walking belt is centered.
b. If the walking belt has shifted to the right, first remove the key
and UNPLUG THE POWER CORD. Using the belt tool, turn the
rear roller adjustment bolt countemlockwise 1/4 of a turn. Plug in
the power cord, insert the key and run the treadmill for a few
minutes. Repeat until the walking belt is centered.
STORAGE
Unplug the power cord when the treadmill is not in use,
Remove the ind=cated bolt and washer from the lower end of each
upright. Loosen the other bolt in each upright. Carefully lay the con-
sole on the treadmill. Keep the bol_sand washers in a secure loca-
tion.
It is recommended that the treadmill be covered during extended
periods of storage.
19