• Operation • Maintenance • Service and Adjustments • Troubleshooting • Español CAUTION: Read the Safety Guidelines and All Instructions Carefully Before Operating. Sears, Roebuck and Co., Hoffman Estates, IL 60170 U.S.A. Visit our Craftsman website: www.sears.com/craftsman D22130 Rev. 1 11/8/01...
How to Stop ......11 If this air compressor fails due to a defect in material or workmanship within one year from the date of purchase, RETURN IT TO THE NEAREST SEARS REPAIR CENTER THROUGHOUT THE UNITED STATES AND SEARS WILL REPAIR IT, FREE OF CHARGE.
SAFETY GUIDELINES - DEFINITIONS SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information, we use the symbols below. Please read the manual and pay attention to these sections. Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
RISK OF BURSTING AIR TANK: THE FOLLOWING CONDITIONS COULD LEAD TO A WEAKENING OF THE TANK, AND RESULT IN A VIOLENT TANK EXPLOSION AND COULD CAUSE PROPERTY DAMAGE OR SERIOUS INJURY. WHAT CAN HAPPEN FAILURE TO PROPERLY DRAIN CONDENSED WATER FROM THE TANK, CAUSING RUST AND THINNING OF THE STEEL TANK.
RISK OF ELECTRICAL SHOCK WHAT CAN HAPPEN YOUR AIR COMPRESSOR IS POWERED BY ELECTRICI- TY. LIKE ANY OTHER ELECTRICALLY POWERED DEVICE, IF IT IS NOT USED PROPERLY IT MAY CAUSE ELECTRIC SHOCK. REPAIRS ATTEMPTED BY UNQUALIFIED PERSONNEL CAN RESULT IN SERIOUS INJURY OR DEATH BY ELEC- TROCUTION.
WHAT CAN HAPPEN TOUCHING EXPOSED METAL SUCH AS THE COMPRES- SOR HEAD OR OUTLET TUBES, CAN RESULT IN SERIOUS BURNS. RISK FROM MOVING PARTS WHAT CAN HAPPEN MOVING PARTS SUCH AS THE PULLEY, FLYWHEEL AND BELT CAN CAUSE SERIOUS INJURY IF THEY COME INTO CONTACT WITH YOU OR YOUR CLOTHING.
“cut-in” pressure. Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a factory set high...
HOW TO SET UP YOUR UNIT Location of the Air Compressor Locate the air compressor in a clean, dry and well ventilated area. The air compressor should be located at least 12" away from the wall or other obstructions that will interfere with the flow of air. The air compres- sor pump and shroud are designed to allow for proper cooling.
“cut-out” pressure. Safety Valve: If the pressure switch does not shut off the air compressor at its “cut-out” pressure setting, the safety valve will protect against high pressure by “popping out” at its factory set pressure (slightly high- er than the pressure switch “cut-out”...
Serious damage may result if the following break-in instructions are not closely followed. This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced. 1. Make sure the On/Auto/Off lever is in the "OFF"...
To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment operating on a daily basis.
Air Compressor Pump Intake and Exhaust Valves Once a year have a Trained Service Technician check the air compressor pump intake and exhaust valves. Motor The motor has an automatic reset thermal overload protector. If the motor overheats for any reason, the overload protector will shut off the motor.
Unplug or disconnect electrical supply to the air compressor. Bleed tank of pressure. Allow the air compressor to cool. To Replace or Clean Check Valve 1. Release all air pressure from air tank. See “To Drain Tank” in the Maintenance section.
8. Protect the electrical cord and air hose from dam- age (such as being stepped on or run over). Wind them loosely around the compressor handle (If so equipped). Store the air compressor in a clean and dry location. 15 - ENG Regulator Arrow Water will condense in the air tank.
Performing repairs may expose voltage sources, moving parts or compressed air sources, moving parts or compressed air sources. Personal injury may occur. Prior to attempting any repairs, unplug the air compressor and bleed off all air tank air pressure. PROBLEM Excessive tank pressure - safety valve pops off.
Page 17
Decrease amount of air usage. Check the accessory air require- ment. If it is higher than the SCFM or pressure supplied by your air compressor, you need a larger compressor. Check and replace if required. Remove and clean, or replace.
Page 18
PROBLEM Motor will not run. D22130 CAUSE Motor overload protection switch has tripped Tank pressure exceeds pressure switch “cut-in” pressure. Extension cord is wrong length or gauge. Check valve stuck open. Loose electrical connections. Possible defective motor or start- ing capacitor. Paint spray on internal motor parts.
DEFINICIONES DE NORMAS DE SEGURIDAD SEGURIDAD Y PREVENCIÓN DE PROBLEMAS DEL EQUIPO: Para ayudar al reconocimiento de esta información, hemos utilizado los símbolos mostrados abajo. Sírvase leer el manual y prestar atención a dichas secciones. Indica una situación de inminente riesgo, la cual, si no es evitada, causará...
Page 21
TANQUE DE AIRE: LAS SIGUIENTES CONDICIONES PUEDEN DETERMINAR EL DEBILITAMIENTO DEL TANQUE, Y ORIGINAR UNA VIOLENTA EXPLOSIÓN DEL MISMO, SIENDO CAUSA DE DAÑOS A LA PROPIEDAD O LESIONES SERIAS. ¿QUÉ PUEDE OCURRIR? DRENAJE INADECUADO DEL AGUA CONDENSADA EN EL TANQUE, SIENDO LA CAUSA DEL ÓXIDO QUE REDUCE EL ESPESOR DEL TANQUE DE ACERO.
Page 22
RIESGO DE DESCARGA ELÉCTRICA ¿QUÉ PUEDE OCURRIR? SU COMPRESOR DE AIRE ESTÁ ACCIONADO POR ELECTRICIDAD. COMO CUALQUIER OTRO DISPOSITIVO ELÉCTRICO IMPULSADO ELÉCTRICAMENTE, SI NO SE LO UTILIZA ADECUADAMENTE, PODRÍA CAUSARLE UNA DESCARGA ELÉCTRICA. LAS REPARACIONES INTENTADAS POR PERSONAL NO CALIFICADO PODRÍAN OCASIONAR SERIAS LESIONES O LA MUERTE POR ELECTROCUCIÓN.
Page 23
RIESGO DE QUEMADURAS ¿QUÉ PUEDE OCURRIR? TOCAR EL METAL EXPUESTO TAL COMO EL CABEZAL DEL COMPRESOR O LOS TUBOS DE SALIDA DEL ESCAPE, PUEDE OCASIONARLE SERIAS QUEMADURAS. RIESGO DE PARTES MÓVILES ¿QUÉ PUEDE OCURRIR? PARTES MOVIBLES TALES COMO LA POLEA, EL VOLANTE Y LA CORREA PODRÍAN SER LA CAUSA DE SERIAS LESIONES SI ELLAS ENTRARAN EN CONTACTO CON USTED O SUS ROPAS.
Familiarícese con los siguientes términos, antes de operar la unidad: Cfm: (Cubic feet per minute) Pies cúbicos por minuto. SCFM: (Stardard cubic feet per minute) Pies cúbicos estándar por minuto; una unidad de medida que permite medir la canti- dad de entrega de aire. PSIG: (Pound per square inch) Libras por pulgada cuadrada.
Desempaque Retire todo el material de empaque dejando al compre- sor de aire sobre la tarima. Retire y descarte los (4) tornillos que sostienen al com- presor de aire en la tarima. Tornillos Puede ser necesario soportar un lado del compresor de aire cuando se retira la tarima porque el compresor de aire tenderá...
CÓMO PREPARAR LA UNIDAD Ubicación del compresor de aire Ubique al compresor de aire en una zona limpia, seca y bien ventilada. La bomba del compresor de aire y su car- casa han sido diseñadas para permitir un enfriamiento ade- cuado.
Conozca su compresor de aire LEA ESTE MANUAL DEL PROPIETARIO Y SUS NORMAS DE SEGURIDAD ANTES DE OPERAR LA UNIDAD. Compare las ilustraciones contra su unidad a fin de familiarizarse con la ubicación de los distintos controles y regulaciones. Conserve este manual para referencias futuras. Descripción de operaciones Familiarícese con estos controles antes de operar la unidad.
Cómo utilizar su unidad Cómo detenerla: Coloque la posición de la llave interruptora On/Auto/Off en la posición "OFF". Antes de poner en marcha Procedimiento para el asentamiento Si las siguientes instruc- ciones no fuesen seguidas estrictamente, podrán ocurrir serios daños.Este procedimiento es necesario antes de poner en servicio al compresor de aire, y cuando la válvula reguladora o la bomba completa del compresor haya sido reemplazada...
Responsabilidades del cliente Verifique la válvula de seguridad Drenaje del tanque Filtro de aire Válvulas de entrada y escape de la bomba del compresor de aire La unidad funciona automáticamente en ciclos cuando está conectada a la energía. Cuando se realizan trabajos de mantenimiento, usted puede estar expuesto a fuentes de voltaje, aire comprimido o piezas en movimiento.
Si está sucio enjuague el filtro de aire con agua tibia y exprímalo hasta que seque. 4. Vuelva a colocar el filtro de aire y su cubierta. NOTA: Si el filtro de aire está sumamente sucio necesitará ser reemplazado. Consulte la sección "Repuestos" para obtener el número correcto de la pieza.
La unidad cicla automáticamente en cuanto la energía eléctrica es conectada. Al efectuar el man- tenimiento, usted quedará expuesto a tensión viva, aire comprimido o partes en movimiento. Debido a tales circunstancias, podrían ocurrirle lesiones personales. Antes de efectuar manten- imiento o reparación alguna, desenchufe el compresor y purgue cualquier presión de aire.
Para reemplazar el regulador Libere toda la presión del aire del tanque. Vea "Drenaje del tanque" en la sección "Mantenimiento". Desenchufe el equipo. Usando una llave de tuercas ajustable retire el medidor de salida de presión y la conexión rápida del regulador (si la tiene). Extraiga el regulador.
GUÍA DE DIAGNÓSTICO DE PROBLEMAS El desarrollo de reparaciones puede exponer a sitios con corriente viva, partes en movimiento o fuentes de aire comprimido que podrían ocasionar lesiones personales. Antes de intentar reparación alguna, desenchufe el compresor de aire y purgue toda la presión de aire del tanque. PROBLEMA Presión excesiva del tanque - la válvula de seguridad se dispara.
Page 34
Decrease amount of air usage. Check the accessory air requirement. If it is higher than the SCFM or pres- sure supplied by your air compressor, you need a larger compressor. Check and replace if required. Remove and clean, or replace.
Page 35
PROBLEMA El motor no funciona. CAUSA El interruptor de protección de s obrecarga del motor se ha abierto. La presión del tanque excede la presión de "corte máximo" del interruptor de presión. El cordón de extensión es del largo o calibre equivocados.
Page 36
Get it fixed, at your home or ours! For repair of major brand appliances in your own home… no matter who made it, no matter who sold it! 1-800-4-MY-HOME To bring in products such as vacuums, lawn equipment and electronics for repair, call for the location of your nearest Sears Parts &...