To Open The Door Manually; Careof Youropener; Operation - Craftsman 139.30437 Owner's Manual

To Openthe Door Manua/ly
DISCONNECT THE TROLLEY:
The door should be fully closed if
possible. Pull down on the
emergency releasehandle (so that
the trolley releasearm snaps into a
vertical position) and lift the door
manually. The lockout feature
prevents the trolley from
reconnecting automatically, and the
door can be raised and lowered
manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release handle
toward the opener at an angle so
that the trolley releasearm is
horizontal. The trolley will reconnect
on the next UP or DOWNoperation,
either manually or by using the door
control or remote.
Trolley
(In Manual
Disconnect
Position)
Lockout position
(Manualdisconnect)
Trolley
Release
Arm
(DownandBack)/
To reconnect
To prevent possible SERIOUSINJURYor DEATHfrom a
falling garage door:
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED.Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Careof YourOpener
MAINTENANCE SCHEDULE
Everymonth
• Manually operate door. If it is unbalancedor binding, call a
trained door systems technician.
• Checkto be sure door opens and closes fully. Adjust if
necessary (refer to Adjustment section).
• Repeatthe safety reversetest. Make any necessary
adjustments (refer to Adjustment section).
Twice a Year
• Check chain tension. Disconnect trolley first. Adjust if
necessary. (See page 11)
Everyyear
• Oil door rollers, bearings and hinges. The garage door opener
does not require additional lubrication. Do not grease the door
tracks.
THE REMOTECONTROLBATTERY
To prevent possible SERIOUSINJURYor DEATH:
• NEVERallow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• ReplaceONLYwith 3V2032 coin batteries.
• DONOT recharge, disassemble, heat above 212° F (100° C)
or incinerate.
The lithium battery should produce
power for up to 5 years.
To replace battery, use the visor clip
or screwdriver blade to pry open the
case as shown. Insert battery positive
side up (+).
Replace the battery with only 3V2032
coin cell batteries.
Dispose of old battery properly. 2
NOTICE: T o comply with FCC and/or Industry Canada(IC) rules, adjustment or modifications of this
transceiver are prohibited. THERE ARE NO USERSERVICEABLE P ARTS.
This device complies with Part 15 of the FCCrules and IC RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Pry open the case first in the
middle (1), then at each side
(2 and 3) with the visor clip.
AVIS : Les r_gles de la FCCet/ou d'lndustrie Canada (IC) interdisent tout ajustement ou toute
modification de ce r6cepteur. IL N'EXISTEAUCUNE PIECESUSCEPTIBLE D'ETREENTRETENUE P AR
L'UTILISATEUR.
Cet appareil est conforme aux dispositions de la partie 15 du r_glement de la FCCet de la norme IC
RSS-210. Son utilisation est assujettie aux deux conditions suivantes : (1) ce dispositif ne peut
causer des interf@encesnuisibles, et (2) ce dispositif dolt accepter toute interf@ence revue, y
compris une interf@encepouvant causer un fonctionnement non souhait6.
34