Attachthe Warninglabels - Craftsman 139.30437 Owner's Manual

Connect Door Arm to Tro//ey (Continued)
ALL0NE-PIECEDOORS
IMPORTANT." Thegroove on the straight door arm MUST face
away from the curved door arm (Figure 5).
1. Close the door. Disconnect the trolley by pulling the emergency
releasehandle.
2. Fastenthe straight door arm and the curved door arm together
to the longest possible length (with a 2 or 3 hole overlap).
3. Attach the straight door arm to the door bracket using the
5/16"x1-1/4" clevis pin. Secure with the ring fastener.
4. Attach the curved door arm to the trolley using the 5/16"x1"
clevis pin. Secure with the ring fastener.
5. Pull the emergency release handle toward the garage door
opener until the trolley release arm is horizontal.
Figure5
CORRECT
INCORRECT
Door
Bracket
Trolley Stop
Bolt Inner
Pulley Trolley
Ring
Fastener
i
StraightDoor
Arm
Clevis Pin
5/16"x1-1/4"
Curved
Door Arm
Outer
Trolley
Bolts
5/16"-18x7/8"
Clevis Pin
5/16"xl"
Emergency
Release Handle
INSTALLATION STEP 10
Attachthe WarningLabels
1. Attach the entrapment warning label on the wall near the door
control with tacks or staples.
2. Attach the manual release/safety reverse test label in a visible
location on the inside of the garage door.
21