Sears Recommends The Following Accessories - Craftsman 113.235110 Owner's Manual

Sears Recommends the Following Accessories
Recommended Accessories
WARNING: To avoid injury from unsafe acces-
sories, use only accessories shown on the rec-
ommended accessories list in this manual.
Prohibited Accessories
The use of any cutting tool except 10" saw blades
which meet the requirement under recommended
accessories is prohibited. Do not use accessories such
as shaper cutters or dado sets. Ferrous metal (metal
with iron in it) cutting and the use of abrasive wheels
are prohibited. See WARNING and CAUTION notes in
the "Safety Instructions For Basic Saw Operations"
Section. If planning to saw non-ferrous metal see those
WARNING and CAUTION notes in the "Safety
Instructions For Basic Saw Operations" Section,
Leg Sets .............................................................. 9-22244
............................................................................ 9-22246
Carbide-Tipped Blades:
Trim Saw ..................................................... See Catalog
Cut-Off ......................................................... See Catalog
Combination ................................................ See Catalog
Plywood/Particle Board .............................. See Catalog
Non-Carbide Tipped Blades:
Cross Cut!Plywood ..................................... See Catalog
Combination ................................................ See Catalog
Clamp ................................................................ 9-29000
Table Extensions ............................................... 9-29001
Crown Molding Jig ............................................. 9-29002
Dust Bag ............................................................ 9-23467
1-1/4" Sawdust Collector Hose ......................... 9-17866
Basic Blade Requirements
10" Diameter
Blades marked for 5,500 RPM or higher
5/8" Diameter Arbor Hole
Wiring Diagram
WHITE
FIELD WINDING
BLACK
--- WIDE BLADE
• I
POWER CORD
WIRE
NUT
D W T:c ?
BRAKE WINDING
>-
n-
O
2 N.C.
....O 3 N_.O. 1COM
SPDT SWITCH
BLUE
BRUSH #1
ISH #2
Circuit Diagram
Trouble Shooting of brake by qualified ser-
vice person only.
1. Check commutation at no load. If there is a heavy
sparking which follows the curvature of the commu-
tator: replace the armature.
2. To continue trouble shooting, now unplug the power
cord.
3. Install new brushes,especially if delayed come-in of
brake has been noticed before failure.
4. Check brake circuit for continuity: remove motor cap
and brushes. Use ohmmeter to check continuity from
brush terminal to brush terminal. If open, locate
exact place using ohmmeter. As indicated by test,
tighten connection or replace field assembly or
replace switch.
5. After repair, check direction of blade rotation vs.
guard arrow.
23