Maintenance And Lubrication; Sears Recommends The Following Accessories; Recommended Accessories - Craftsman 113.235140 Owner's Manual

Maintenance and Lubrication
2, Lubrication of mechanism which pivots lower guard:
(see picture on previous page) Use light household oil
(sewing machine oil) or a pressurized light spray oil on
metal-to-metal or metaHo-plastic guard contact areas
as required for smooth, quiet operation. Avoid excess
oil, to which sawdust will cling Lubricate the lower
guard spacer, roller, pivot plate and link pivot..
3. Lubrication of miter index indents: use a small amount
of grease on the miter index indents that are located
below the miter scale on the front of the unit..
(continued) ..........................
Sears Recommends the Following Accessories ......... ................
Recommended Accessories
WARNING: To avoid injury from unsafe accesso-
ries, use only accessories shown on the recom-
mended accessories list in this manual.
Leg Set ...................................................................................... 9-22246
Dust bag ............................................................................... 9-23467
Workpiece Clamp ....................................................... 9-29000
Table Extensions with Stop Block .................................. 9-29001
Crown molding jigs ............................................................ 9-29002
1-1/4 Sawdust Collection Hose ................................... 9-17866
CAUTION: Use only blades labeled thin-kerr and
recommended for use on miter saws. Standard kerf
12" blades may cause blown fuses, and increased
mechanical/electrical wear on the saw° Standard
kerr 12" blades take a longer time to start and stop,
which could have an effect upon your safe opera-
tion.
Basic Blade Requirements
12" Diameter
Blades marked for 4,000 RPM or higher
1" Diameter Arbor Hole
Labeled "Thin ked"
Carbide Tipped Sawblades
WARNING: Read warnings and conditions on your
carbide sawblade.
Do not operate saw machine without proper saw-
blade guard in place. Carbide is a very hard but
brittle material. Care should be taken while mount-
ing, using and storing carbide blades to prevent
accidental damage. Slight shocks, such as striking
tip during handling, can seriously damage the
blade. Foreign objects in the workpiece, such as
wire or nails, can also cause tips to crack or break
off. Never use blade on saw machine that will
exceed maximum recommended blade R°P.M.
Always wear proper eye protection which complies
with current ANSI standard Z87.1 when using any
power tool. Before using, always: visually examine
blade and tips for bent blade, cracks, breakage,
missing or loose tips; or other damage. Do not use
if damage is suspected. Mount blade securely in
proper rotation direction. Failure to heed all safety
instructions and warnings regarding use of this
product can result in serious bodily injury.
Prohibited Accessories
WARNING: The use of any cutting tool except 12"
saw blades which meet the requirement under rec-
ommended accessories is prohibited. Do not use
accessories such as shaper cutters or dado sets.
Ferrous metal (metal with iron in it) cutting and the
use of abrasive wheels are prohibited. See WARN-
ING and CAUTION notes in the "Safety Instructions
for Basic Saw Operations" section. If planning to
saw non-ferrous metal, see WARNING and CAU-
TION notes in the "Safety Instructions for Basic
Saw Operations" section.
25