Hoover FloorMate SpinScrub Hard Floor Cleaner Manual page 18

Use the list below to help solve minor problems.
Cleaner won't run
Low suction
Water puddling behind cleaner
Won't pick up dirty solution
Cleaner pushes a line of dry debris
in front of it
Cleaning solution won't dispense
Brushes won't rotate
18
,/Make sure the cleaner is
plugged in firmly.
,/Check the fuse or breaker.
,/Empty the recovery tank; it may be full
and the automatic shut-off engaged.
,/Make sure filter and filter lid are properly
positioned.
,/Make sure tanks are locked in place.
¢' Check the filter and clean if dirty.
¢' Make sure nozzle is replaced properly
and locked.
,/Make sure the hose door is closed tightly
when not using the hose.
¢' Use recommended detergents to reduce
excess foaming.
,/Make sure solution tank is installed
properly.
_/Empty recovery tank.
,/Check Mode selector dial to ensure it is
set for WET PICKUP.
,/Make sure recovery tank is installed
properly.
,/Empty recovery tank.
,/Make sure filter and filter lid are properly
positioned.
,/Check Model selector dial to ensure it is
set for DRY VAC.
¢' Tip nozzle off floor by pushin_ down on
handle to pick up debris that ig too large
to clear the squeegee.
,/Make sure solution tank is locked in
position.
,/Refill the solution tank if it is empty.
_/Pump needs to b_e primed (when using
tool). See page lb.
,/Check Mode selector dial to ensure it is
set for WASH.
,/Reset circuit breaker.
(1) Push ON/OFF switch to turn cleaner
OFE
/il
Walt one minute.
Plugthe cleaner into electrical outlet.
Pus{1 the ON/OFF switch again to
turn cleaner ON.
If the brushes continue to stall and the
breaker trips again, clean the brushes to
remove debris.