Speaker Connections To Tvs - Sharp HT-SB200 Operation Manual

Speaker connections to TVs

HT-SB200
Caution:
Turn off all other equipment before making any connections.
Tuner receiving for other audio system
●
Placing the aerial near the speaker AC power lead may cause
noise pick up. Place the aerial away from the speaker for
better reception.
Notes:
●
To connect to TV, use either LINE IN 1 sockets or AUDIO
LINE IN 2 socket only.
●
Refer the operation manual of the equipment to be
connected.
●
Fully insert the plugs to avoid fuzzy pictures or noises.
■ Connecting to a TV
If the TV/monitor has an audio output, connect it to the LINE IN
1 sockets on the rear of the speaker.
TV
12
To audio output sockets
RCA cable (supplied)
To LINE IN 1
sockets
Speaker
■ Connecting to a TV (with Headphone socket)
If the TV/monitor has headphone socket, connect it to the
AUDIO LINE IN 2 socket on the rear of the speaker.
TV
Audio cable
(3.5 mm/stereo socket)
(not supplied)
Speaker
Notes:
●
If the TV volume is continuously in low level, the speaker will
automatically power off. Increase the TV output volume to
enjoy the sound from the speaker.
●
If the speaker volume is continuously in very high level, the
speaker will mute and recover after 3 seconds.
HEADPHONE
To HEADPHONE socket
To AUDIO LINE
IN 2 socket