Bass Control - Sharp HT-SB200 Operation Manual

Remote control operation:
Press the VOL + button to increase the volume and the VOL –
button to decrease the volume.
■ Muting
The volume is muted temporarily when pressing
the MUTE button on the remote control. Press
again to restore the volume.
■ Preset sound mode
Main unit operation:
When the SURROUND button is pressed, the current mode
setting will light up. To change to a different mode, press the
SURROUND button repeatedly until the desired sound mode
lights up.
Remote control operation:
Press a desired sound mode on the remote control.
STANDARD CINEMA/GAME
NEWS
SPORT
WOW HD off
STANDARD
WOW HD on for cinema/game sound effect
CINEMA/GAME
WOW HD on for sport broadcasting
SPORT
WOW HD on for news
NEWS
■ Subwoofer level control
The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL button.
To decrease the level, press the
SUBWOOFER LEVEL button.
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.

■ Bass control

1. Press the BASS/TREBLE button
to select "BASS".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
■ Treble control
1. Press the BASS/TREBLE button
to select "TREBLE".
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
■ Function
When the FUNCTION button on
speaker or LINE button on the remote
control is pressed, the input source
will change. Press the FUNCTION
button on speaker or LINE button on
the remote control repeatedly to
select desired input source.
Note:
The backup function will protect the memorised function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
Auto power on function:
When you press the LINE button on the remote control, the
speaker will turns on at last function.
Auto power off and auto detect signal:
●
If no signal is detected for 1 minute during power on, the
speaker will automatically go to stand-by mode. The STAND-
BY indicator turns orange.
●
The speaker will automatically power ON if it detects audio
-5 -4 ... 4 5
signal from connected equipment.
HT-SB200
-5 +5
-5 +5
LINE 1
LINE 2
15