Speaker connections to TVs
HT-SB200
Caution:
Turn off all other equipment before making any connections.
Tuner receiving for other audio system
●
Placing the antenna near the speaker AC power cord may
cause noise pick up. Place the antenna away from the
speaker for better reception.
Notes:
●
To connect to TV, use either LINE IN 1 jacks or AUDIO LINE
IN 2 jack only.
●
Refer the operation manual of the equipment to be
connected.
●
Fully insert the plugs to avoid fuzzy pictures or noises.
■ Connecting to a TV
If the TV/monitor has an audio output, connect it to the LINE IN
1 jacks on the rear of the speaker.
TV
14
To audio output jacks
RCA cable (supplied)
To LINE IN 1
jacks
Speaker
RIGHT
LEFT
LINE IN 2
LINE IN 1
■ Connecting to a TV (with Headphone jack)
If the TV/monitor has headphone jack, connect it to the AUDIO
LINE IN 2 jack on the rear of the speaker.
TV
Audio cable
(3.5 mm/stereo jack)
(not supplied)
Speaker
Notes:
●
If the TV volume is continuously in low level, the speaker will
automatically power off. Increase the TV output volume to
enjoy the sound from the speaker.
●
If the speaker volume is continuously in very high level, the
speaker will mute and recover after 3 seconds.
HEADPHONE
To HEADPHONE jack
To AUDIO
LINE IN 2 jack
RIGHT
LEFT
LINE IN 2
LINE IN 1