Changing The Default Setting Of The Amplifier - Sharp HT-M700H Operation Manual

Changing the default setting of the amplifier

Change settings according to the connected speakers.
Speaker delay setting (See page 51.)
Speaker level setting (See page 52.)
Test tone (See page 52.)
Example:
If the right surround speaker is 3.3 m (10 feet) away from the listen-
ing position, change settings as shown below (adjust the SR).
CT
FR
FL
SW
SL
SR
Default setting: 2 m (6 feet)
1 In "Speaker delay setting", set the right surround speaker (SR)
to 3.3 m (10 feet).
2 In "Speaker level setting", slightly increase the level of the right
surround speaker as it is a little farther than others (see page
52).
3 In "Test tone", check the sound from each speaker (see page
52).
CT
FR
FL
SW
3.3 m
SL
(10 feet)
SR
Speaker type
FL Front speaker (Left)
CT Centre speaker
FR Front speaker (Right)
SR Surround speaker (Right)
SL Surround speaker (Left)
SW Subwoofer
Default settings:
Delay - - - 2 m (6 feet)
Level - - - 0 dB (FL, CT, FR, SR, SL), + 5 dB (SW)
If you press during
the operation, you
can go back one step.
Delay range Level range
0.1 to 9.0 m - 6 dB to + 6 dB
0.1 to 9.0 m - 6 dB to + 6 dB
0.1 to 9.0 m - 6 dB to + 6 dB
0.1 to 9.0 m - 6 dB to + 6 dB
0.1 to 9.0 m - 6 dB to + 6 dB
- 10 dB to + 10 dB
HT-M700H
50