G Enabling Scanning Margins (Void Area) - Sharp AR-NB3 Network Scanner Operations

HOW TO USE THE NETWORK SCANNER FUNCTION
3
Press the [OK] key.
BACK OK
GHI
4
Select the desired threshold value
with the [ ] or [ ] key.
The default setting is "128". White becomes stronger
as the displayed value approaches "1". Black becomes
stronger when the displayed value approaches "254".
ENABLING SCANNING MARGINS (VOID AREA)
When this function is enabled, margins (void areas that are not scanned) are created around the edges of the machine's
maximum scanning area.
Select scan mode, place the original (steps 1 to 3 on
The factory default setting for the void area is "ON" (enabled).
If you need to change the void area setting, follow these steps.
Void area: 2.5 mm (7/64") from the top and bottom edges
3.0 mm (1/8") from the left and right edges
1
Press the [SPECIAL FUNCTION] key in
scan mode.
Perform this operation from the
2-SIDED
base screen of scan mode.
COPY
SPECIAL FUNCTION
When the [SPECIAL
DUPLEX SCAN
FUNCTION] key is pressed, the
ACC.
special function menu appears.
(To select scan mode, see step
1 on
2
Select "VOID AREA" with the [ ] or
[ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
30
B/W THRESHOLD
128
(1~254)
page 20.)
SPECIAL FUNCTION
B/W THRESHOLD
LIGHT SOURCE
VOID AREA
PAPER SIZE SET
5
Press the [OK] key.
OK
page 20), and then follow the procedure below.
3
Press the [OK] key.
BACK OK
4
Select "ON" or "OFF" with the [ ] or
[ ] key.
5
Press the [OK] key.
OK
The set value is stored and you
return to the base screen.
GHI
VOID AREA
ON
OFF
The setting is stored and you
return to the base screen.