Sharp FO-475 Operation Manual page 54

Remote Operations
5
When you have finished listening to your
messages, you can do any of the
following:
Erase all messages: To erase all of the
messages in the box, press "3", "3",
and "#".
Repeat playback: To listen to your
messages again, press "7" and "#".
Perform other operations: You can
enter any of the commands described in
the following section, "Other remote
operations".
Hang up: If you do not erase your
messages first, they will be saved and
any new messages will be recorded
after them. If you want the FO-475 to
resume normal operation immediately,
*
press " " twice before hanging up (in
some cases, particularly when the
Transfer function is used, the FO-475
may not accept new calls for one or
two minutes after you hang up unless
you first press "
Comments:
When a remote command is accepted by the machine, you will hear one
beep. If an incorrect command is entered, you will hear four beeps. In the
latter case, re-enter the correct command.
When entering a command, do not pause longer than 10 seconds between
each digit. If you do, a 4-beep error signal will be issued and the digits
entered up to that point will be disregarded. In this case, re-enter the
command from the beginning.
If you make two errors (causing two 4-beep signals to be issued) while
entering your remote code number, the line will be disconnected. This
prevents unauthorized people from attempting to guess your remote code
number.
If you pause for longer than 60 seconds before entering a command, you will
be disconnected.
42
*
" twice).
3 3
7