Optical Drive Module - Toshiba Tecra A3 Maintenance Manual

4 Replacement Procedures
4.5

Optical Drive Module

Removing the Optical Drive Module
To remove the optical drive module, you need to remove the HDD module first. Follow the steps
below:
1. Turn the computer upside down.
2. Remove one M2.5x3 screw securing the optical drive module into place.
3. Slide the Slim Select Bay latch to unlock position.
4. Grasp the optical drive module and slide it out.
1
Installing the Optical Drive Module
To install a device in the optical drive module bay, follow the steps below and refer to the figure
in the preceding section.
1. Slide the device into the optical drive module bay.
2. Use one M2.5x3 screw to secure it in position.
3. Slide the Slim Select Bay latch to lock position.
4-12
M2.5 X 3
3
Figure 4-8 Removing the optical drive module
2
Slim Select
Bay latch
Tecra A3/S2 Series Maintenance Manual