Toshiba Tecra A3 Maintenance Manual page 22

1.2 System Unit
Marvell 88E8053 for Giga LAN
• PCI Express base specification 1.0a compliant
• x1 PCI Express interface with 2.5 GHz signaling
• Advanced error reporting
• Message signaled interrupts
• Configurable 48 KB deep buffer
• On-chip VLAN insertion and removal
• TCP, IP, UDP Checksum offload
• Compliant to 802.3x flow control support
• 10/100/1000 IEEE 802.3 compliant
• Automatic MDI/MDIX crossover at all speeds
• Wake On LAN(WOL) power management support
• Compliant to ACPI 2.0 specification
• Smart power down when link is not detected
• Marvell Virtual Cable Tester(VCT) for advanced cable diagnostics
Marvell 88E8036 for 10/100M LAN
• PCI Express base specification 1.0a compliant
• x1 PCI Express interface with 2.5GHz signaling
• Active state power management (L0s) support
• Advanced error reporting
• Configurable 4KB deep buffer
• Message signaled interrupts
• Compliant to 802.3x flow control support
• 10/100 IEEE 802.3 compliant
• Wake On LAN(WOL) power management support
• Compliant to ACPI 2.0 specification
• Smart power down when link is not detected
• Power regulator outputs for 2.5V and 1.2V supplies
Marvell 88SA8040 for Serial ATA Bridge
• ATA/ATAPI PIO mode data transfer
• ATA/ATAPI Ultra DMA(UDMA) data transfer rates of 16.7, 25, 33, 44, 66, 100,
133 and 150MB/s
• Serial ATA power save modes
• Serial ATA hot-plug
• Enhanced receiving FIFO flow control for Serial ATA link
• DMA Command Queuing(maximum 32 entries
• Supports 20, 25, 30, or 40MHz reference clock.
• Serial ATA Interface of 1.5Gbps
• Full scan for high production test coverage
Tecra A3/S2 Series Maintenance Manual
1 Hardware Overview
1-13