Table of Contents
Advertisement
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters "sleep mode." This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the P
button. You
Power
can turn sleep mode on or off
through the Extended menu.
See page 64.
Turn off this product when
not in use to prolong the life
of the projector.
caution
To avoid damaging the
projector or lamp, never
unplug the power cord
when the power light is
green or flashing orange.
Projecting
42
Shutting Down the Projector
When you've finished using the projector, follow the recommended
procedure to shut it down:
1. If you're using a computer, shut it down first; otherwise you may
not be able to see your computer's display to shut it down
properly.
2. To turn off the projector, press the P
projector or remote control.
You see this confirmation message:
(If you don't want to turn it off, press
any other button or wait a few
seconds until it disappears.)
3. Press the P
Power
lamp is turned off, and the power light turns orange.
With Epson's exclusive Instant Off
cool-down period, so you can pack up and go immediately after
turning off the projector.
If you want to turn the projector on again, press the P
button.
4. Press up on the blue foot release lever and lower the projector to
retract the front adjustable foot.
5. Close the
A/V Mute
6. Unplug the power cord.
7. Turn off and disconnect any equipment
plugged into the projector.
8. If you won't be using the projector for
awhile, store it in the soft case that came
with it or in a protective case.
Power
button again. The projector beeps twice, the
®
technology there's no
slide.
button on the
Power
Advertisement
Table of Contents
