Shutting Down The Projector - Epson PowerLite 830p User Manual

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the red P
projector or remote control.
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
3. Press the P
Power
lamp is turned off, and the
30 seconds as the projector cools down. After the projector has
cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the P
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
6. If you're using a remote control, set its
Power
button again. The projector beeps twice, the
light flashes orange for about
Power
Power
ON/OFF
button on the
Power button
button.
switch to .
OFF
Displaying and Adjusting the Image
note
You can set the projector to
automatically turn off the
projector lamp and enter
"sleep mode" when it has not
received any signals for 30
minutes. This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the P button.
Power
If you are done using the
projector, unplug the power
cord. To turn off sleep
(standby) mode, see page 75.
caution
Turn the projector off when
not in use. Continuous
24-hour-a-day use may
reduce the projector's overall
life.
29