On-Line Configuration Programming - Sharp UP-3301 Instruction Manual

On-line Configuration Programming

Use the following procedure to select the on-line configuration programming.
Please consult your dealer for more details.
Procedure
M
216
1.
In the SETTING window, select "18 ONLINE CONFIG".
• The ONLINE CONFIG window will appear.
2.
Program each item as follows:
• TERMINAL No. (Use the numeric entry)
Terminal number (0 to 999999).
• CI SIGNAL (Use the selective entry)
Sensing of the CI signal
NON
SENSING
• LINE FORM (Use the selective entry)
Programming of the modem control
FULL: Full duplex system
HALF: Half duplex system
• BAUD RATE (Use the selective entry)
Transmission data rate
38400 bps 19200 bps
4800 bps 2400 bps
600 bps 300 bps
(1200 bps, 600 bps, 300 bps: These baud rates are not
available for CH2.)
• START CODE (Use the numeric entry)
Start code (0 to 127)
• END CODE (Use the numeric entry)
End code (0 to 127)
• TIME OUT (Use the numeric entry)
Programming of the time-out time (1 to 255 sec.)
9600 bps
1200 bps