Sharp XL-MP100H Operation Manual page 31

The connection lead is not included. Purchase a commercially avail-
able lead as shown below.
White
Red
RCA lead
(not supplied)
White
Red
To the line output sockets
Connection cable
To the optical line
for digital recording
input socket
(not supplied)
! Listening to the playback sounds from VCR,
DVD, etc.
1 Use a connection lead to connect the VCR, DVD, etc. to the VID-
EO/AUX IN sockets.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the FUNCTION button until "AUX" appears on the display.
When operating with the remote control, press the VIDEO/AUX
button.
4 Play the connected equipment.
Note:
To prevent noise interference, place the unit away from the televi-
sion.
! To record CD signals on MDs
VCR, DVD, etc.
The digital signal from this unit can be recorded by MiniDisc record-
ers, etc.
1 Remove the DIGITAL OUT socket cover.
2 Use a connection cable for digital recording to connect the unit to
the OPTICAL IN socket of a MiniDisc recorder, etc.
3 Press the ON/STAND-BY button to turn the power on.
4 Put the MiniDisc recorder, etc. in the recording mode.
5 Play a CD on this unit.
MD recorder
Notes:
" When using the optical digital socket, remove the cap first. After
using the socket, replace the cap.
" Only CD signals can be output.
! To record on a tape
1 Load a cassette into the cassette compartment with the side to
be recorded on facing you.
2 Press the VIDEO/AUX button.
3 Press the TAPE
4 Press the
5 Play the VCR, DVD, etc.
04/1/28
( ) button.
( ) button.
XL-MP100H(A)3.fm
XL-MP100H
8
31
TINSEA014SJZZ