Enhancing Your System; Timer And Sleep Operation - Sharp XL-MP100H Operation Manual

Timer and sleep operation (continued)
XL-MP100H
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, press the SLEEP button until "OFF" appears on the
display.
To confirm the remaining sleep time:
Press the SLEEP button once whilst the sleep timer is set.
The remaining sleep time is displayed for about 3 seconds.
! To use timer and sleep operation together
Example: To fall asleep and wake up to the same radio station
You can play back the same source only (the function cannot be
switched).
1
Set the sleep time (steps 1 - 2, page 29).
2
Whilst the sleep timer is set, set the desired playback time
(steps 4 - 6, pages 28 - 29).
Sleep timer setting Timer playback setting
5 minutes - 3 hours
Sleep operation will
automatically stop.
Caution:
When using the cassette deck, be sure the tape length is long
enough to perform both functions. If you want to sleep and wake up
listening to a tape, and the length of the tape is shorter than the
sleep timer setting, timer playback will not be possible.
30

Enhancing your system

! Headphones
" Before plugging in or unplugging the headphones, reduce the vol-
ume.
" Be sure your headphones have a 3.5 mm (1/8") diameter plug
Timer playback and are between 16 ohms and 50 ohms impedance. The recom-
start time mended impedance is 32 ohms.
" Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
04/1/28 XL-MP100H(A)3.fm
TINSEA014SJZZ