Sharp XL-MP100H Operation Manual page 16

Advanced CD or MP3 disc playback (continued)
XL-MP100H
! Programmed play
You can choose up to 20 selections for playback in the order you
like.
1
Whilst in the stop mode, press the MEMORY (MEMORY/
SET) button to enter the programming save mode.
2
Press the direct search buttons
on the remote control to select
the desired track.
You can also select a track by pressing the
3
Press the MEMORY (MEMORY/
SET) button to save the track
number.
4
Repeat steps 2 - 3 for other tracks. Up to 20 tracks can be
programmed.
If you make a mistake, the programmed tracks can be cleared
by pressing the CLEAR button.
5
Press the ( ) button to start playback.
16
To clear the programmed selections:
Whilst the "MEMORY" indicator is lit, set the CD to the stop mode
and then press the CLEAR button.
Each time the button is pressed, one track will be cleared, beginning
with the last track programmed. When all the tracks are cleared,
"MEMORY" will disappear.
Adding tracks to the programme:
If a programme has been previously stored, the "MEMORY" indica-
tor will be displayed. Then follow steps 2 - 3 to add tracks. The new
tracks will be stored after the last track of the original programme.
Notes:
" If you open the disc tray or enter the stand-by mode, the pro-
grammed sequence is automatically cancelled.
" Even if you changed the function from CD to some other function,
the programmed selections will not be cleared.
" During the programme operation, random play is not possible.
" For MP3 discs, you can select the track number but cannot select
the folder by pressing the direct search button(s).
! Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
Selected track number
tion and player.
or button. " Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
" Keep your discs away from direct sunlight, heat, and excessive
moisture.
" Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
Playback order
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
04/1/28
NO
YES
Correct
XL-MP100H(A)2.fm
TINSEA014SJZZ