Brother MFC-J5910DW Quick Setup Manual page 23

Wired Network
For wired network interface users
17
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
Note
• For Mac OS X 10.4.0 to 10.4.10 users, upgrade
to Mac OS X 10.4.11 - 10.6.x.
• If you have previously set up your machine for
a wireless network and then want to set it up on
a wired network, you should check that the
machine's Network I/F is set to
Wired LAN. The wireless network interface
will become inactive with this setting.
On your machine, press Menu.
Press s or t to display Network, and then
press Network.
Press s or t to display Network I/F, and
then press Network I/F.
Press Wired LAN.
Press Stop/Exit.
(Mac OS X 10.4.11, 10.5.x, 10.6.x)
18
Connect the network
cable
a
Lift the scanner cover until it locks securely into
the open position.
b
You will find the Ethernet port marked with a
symbol inside the machine on the left as
shown below. Remove the protective cap and
connect the network cable to the Ethernet port.
USB
Macintosh
23