For Macintosh Users - Brother MFC-J5910DW Quick Setup Manual

For Wireless Network Users
One-push configuration
19
using WPS or AOSS™
(Windows
Macintosh)
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c
On your machine, press Menu.
Press s or t to display Network, and then
press Network.
Press WLAN.
Press s or t to display WPS/AOSS, and then
press WPS/AOSS.
When Network I/F switched to
Wireless. is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of Wi-Fi Protected Setup in the
Network User's Guide.
d
When the LCD shows Start WPS or AOSS,
press the WPS or AOSS™ button on your
wireless access point/router. See the user's
guide of your wireless access point/router for
instructions.
Then press OK and your machine will now
automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
®
and
e
A connection result message appears for
60 seconds on the LCD and a WLAN report will
automatically be printed.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 34.
Wireless setup is now complete. A four
level indicator at the upper left your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 20.
®
For Windows Users:
Now go to
Page 36

For Macintosh Users:

Now go to
Page 39
33