Perfsetporteemask - HP StorageWorks 8B - FC Entry Switch Reference Manual

1
Telnet Commands

perfSetPortEEMask

Set overall mask for end-to-end (EE) monitors.
Synopsis
perfSetPortEEMask port,"TxSIDMsk","TxDIDMsk","RxSIDMsk","RxDIDMsk"
Availability
admin
Description
Use this command to set the mask for the EE monitors of a port. This command enables a user to
selectively choose the kind of Fibre Channel frames in which the number of words are to be
counted.
EE monitors are defined by the perfAddEEMonitor command using SID and DID pairs. This
command can be used to match the entire SID or DID to trigger the monitor to count Fibre Channel
words. It can also be used to match one or two of the three fields (Domain ID, Area ID and ALPA
ID) in SID and DID pair to trigger the monitor.
The EE mask is used to setup a flag on each field to control whether the field is used to trigger the
monitor.
When a flag bit is set (ff), the corresponding field will be used to qualify the triggering of the
monitor. If a flag is reset (00), then that field is ignored and its value will not be used to qualify
monitor-triggering.
There is only one EE mask per port. The mask is applied to all eight EE monitors available on a
port. The default EE mask value upon power-on is all eight EE monitors set. When you reset mask,
the counters are also reset to 0.
Operands This command has the following operands:
port
TxSIDMsk
TxDIDMsk
RxSIDMsk
RxDIDMsk
1-158
Specify the port number where you want to modify the end-to-end monitors. This
operand is required.
Specify the source ID mask in "dd:aa:pp" format, where "dd" is Domain ID
mask, "aa" is Area ID mask and "pp" is ALPA ID mask. For example, "00:ff:00"
uses TxSID Area ID to trigger EE monitor comparison.
Specify the following values to turn on or off a specific field:
00 - Specifies that the field does not trigger EE monitors.
ff - This specifies that the field triggers EE monitors.
This operand must be enclosed in quotation marks. This operand is required.
Specify the destination ID mask in "dd:aa:pp" format. This operand must be
enclosed in quotation marks. This operand is required.
Specify the source ID mask in "dd:aa:pp" format. This operand must be enclosed
in quotation marks. This operand is required.
Specify the destination ID mask in "dd:aa:pp" format. This operand must be
enclosed in quotation marks. This operand is required.
Fabric OS Reference