Ipaddrset - HP StorageWorks 8B - FC Entry Switch Reference Manual

1
Telnet Commands

ipAddrSet

Set ethernet and FC IP addresses.
Synopsis
ipAddrSet
Availability
admin
Description
Use this command to set the ethernet and FC IP addresses. You are prompted for:
Ethernet IP Address
Ethernet Subnetmask
Fibre Channel IP Address
Fibre Channel Subnetmask
Gateway Address
After each prompt the current value is shown. You may:
•
Press return to retain the current value
•
Enter an IP address in conventional dot notation
•
Enter none
•
Press control-C to cancel changes
•
Press control-D to accept changes and end input
The final prompt allows you to set the new IP addresses immediately; enter y to set new addresses
immediately, enter n to delay the changes until the next switch reboot. Entering y closes the telnet
session.
The default IP address for a switch is 10.77.77.77.
A change to these values issues a domain address format RSCN, refer to FC-FLA for a description
of RSCNs.
Operands
None.
Example To enable IP over Fibre Channel:
See Also
ifShow
ipAddrShow
1-108
IP address of the ethernet port.
IP subnet mask of the ethernet port.
IP address of the Fibre Channel ports.
IP subnet mask of the Fibre Channel ports.
IP address of the gateway.
switch:admin> ipAddrSet
Ethernet IP Address [192.168.1.65]:
Ethernet Subnetmask [none]:
Fibre Channel IP Address [none]: 192.168.65.65
Fibre Channel Subnetmask [none]:
Gateway Address [192.168.1.1]:
Committing configuration...done.
Set IP addresses now?
[y = set now, n = next reboot]: y
Fabric OS Reference