Zenith SR2745 Operating Manual & Warranty page 77

What you should do when you get a
new VCR
NOTE: THIS PROCEDURE REQUIRES THE USE
OF THE UNIVERSAL REMOTE.
Make sure your Remote Emitter is positioned 2-3 inches in
front of your new VCR. Find the code(s) for your brand of
new VCR on the "VCR Code" chart and write the code(s)
here.
l. Press TO DO until you see the StarSight Setup menu.
2.
Press the $ to highlight "Change VCR."
Change Channel Order
Change Cable Box/Service
Change VCR
Re-Activate/Change Address
StarSight Demonstration
Use t, then STAR to choose
To exit, press QIJIT
_ CNN i_ C B L I 5 : 0 2 P
3.
Press STAR and follow the on-screen instructions.
Select Guide Channels
Change Channel Order
Change Cable Box/Service
Re-Activate/Change Address
StarSight Demonstration
Use t, then STAR to choose
To exit, press QIJIT
_ _HN : CBL 5:02P
YOU SHOULD ALSO KNOW...
• It is important that your equipment works properly
during each test. For example, make sure your VCR
turns "on. If the equipment does not respond, you
need to try another VCR code and test your VCR
again.
• Remember to reprogram your remote so it can
operate your new VCR. See the section on
"Universal Remote Control" in the TV portion of
this guide.
• If you have tried all the codes and need assistance,
call the StarSight Help Desk at (800) 628-STAR.
What changes are you making
to your VCR?
.
2
2,
Add VCR
Replace VCR
Remove VCR ......
Enter your selection here:
To continue, press ENTER.
l'o exit, press QUIT.
13-I