Zenith SR2745 Operating Manual & Warranty page 47

Step 4. Checking Your StarSight Setup
If you do not have a VCR or Cable Box, proceed to
number 4.
Now that you've activated StarSight, the final step is to
test your equipment setup. Here's how:
I,D Press ENTER/TUNE on your remote control when
you see the "Congratulations ?" message.
StarSight will now guide you through a series of
on-screen displays. Please follow the instructions
carefully. All you have to do is respond to the
on-screen prompts. If you're using a VCR, you'll be
prompted to insert a videotape that can be used for a
30-second recording test.
2o
Find the (;able Box and VCR codes on your
StarSight Checklist.
If you've listed more than one code for a given
brand of Cable Box and VCR, don't worry:
StarSight lets you test each code until the correct
one has been found.
Be sure the Remote Emitters you placed previously
are positioned according to the instructions earlier in
this section.
,
o
Follow the on-screen instructions until you see a
screen that says: Congratulations!
If you have any difficulty finding the correct code or
getting your VCR or Cable Box to respond, call the
StarSight Help Desk at (800) 628-STAR.
Your StarSight System ._s:now all set up and ready
to collect program information. You'll begin to
receive StarSight program information whenever
your TV is turned off or ttxned to your PBS station.
Initially, it will take between 4 and 12 hours to
collect program information, so we recommend that
you simply wait overnight. While your "IV :is off, it
will gather the information that it needs Following
this initial process, your system will automatically
be updated with the latest program info_xnation any
time your TV is turned off.
II
YOU SHOULD ALSO KNOW...
It is important that you:
• Always be sure your TV set is plugged in.
• Always leave your Cable Box ON, otherwise you risk losing your StarSight program information.
• Be sure,you leave your VCR OFF when it's not being used. tf you forget to turn off your VCR, a scheduled recording
cannot occur.
• It will normally take from 3 to 5 seconds for Cable Box channels to change. This is the tiptoe it takes for the Flemote
Emitter's infrared signal to communicate with your Cable Box.
A-7