Add Hardware; Remove Hardware - HP StorageWorks 8000 - NAS Installation And User Manual

NAS Data Path Manager
4. Click the Mode box of the path you wish to change.
5. Select the desired mode for the path (alternate or preferred) from the available

Add Hardware

After adding arrays or LUNs to your system, you can configure the paths to them.
The recommended progression is as follows.
1.
2.
3.
Continue making changes to your paths and monitoring performance until you
achieve improved performance.

Remove Hardware

When you add, maintain, remove, or exchange hardware (such as switches or
cables), you often know your paths will change. NAS Data Path Manager allows
you to plan the interruption of the normal flow of operations in order to make the
hardware change.
1. From the Storage tab, select Volume Groups, and use the tree view (second
2. Complete the hardware change.
3. Scan for new hardware, as discussed in the
4. Restore the paths you set to off-line, according to the section on page 29.
Note:
changes to the path settings.
30
options that appear, then click OK.
Accept the Default Settings.
Remove Hardware as described at on
Manage the Data Paths, if appropriate.
icon to the right of Actions) to view path information. (You can go to either
the table view or tree view from the actions menu as well.)
section on page 29.
Accept the default configuration and monitor performance before making any
hp StorageWorks NAS Data Path Manager Installation and User's Guide
page 30.
Accept the Default Settings