Install Nas Data Path Manager; Prerequisites; Install The Software; Enable And Disable The Software - HP StorageWorks 8000 - NAS Installation And User Manual

Install NAS Data Path Manager

Prerequisites

See

Install the Software

Use the NAS Data Path Manager software CD and the command line interface to
install NAS Data Path Manager.
1. On the NAS 8000 server, insert the CD into the server's CD-ROM drive.
2. On a computer on the network, access the command line interface:
3. Execute the following commands.
4. Remove the CD from the CD-ROM drive.

Enable and Disable the Software

Enable and disable NAS Data Path Manager from Command View NAS.
1. If you had a browser open, close and re-open it, so that it finds the DPM
2. Select the Applications tab.
3. Select NAS Data Path Manager.
hp StorageWorks NAS Data Path Manager Installation and User's Guide
System Requirements
a. On an MS Windows system, Select Start > Run. (This step is not
necessary for UNIX/Linux systems.)
b. Execute:
telnet <nas_8000_hostname_or_IP_address>
c. Log in as admin and use a password, if prompted.
installSystemPackage
cdrom://hpNasOs-DataPathManager-1.0-0.i386.rpm
installSystemPackage
cdrom://hpNasOs-DataPathManager-authorize-1.0-
0.i386.rpm
The software is installed, but not yet enabled.
software.
on page 10.
NAS Data Path Manager
15