Snapshot Properties - HP StorageWorks 8000 - NAS User Manual

Snapshot Properties

To edit snapshot properties:
1. In Command View NAS, click the Configuration tab.
2. Navigate to NDMP Properties.
3. Select Actions > Edit Snapshot Properties.
4. Enter the Snapshot Volume Percentage. This lets you define the size of the
5. Select the Snapshot Behavior. This controls the behavior of taking snapshots
6. Click OK.
Note:
to perform an incremental backup, select Backup Without Snapshot.
When using snapshots, NDMP creates the snapshot just before the backup, then
backs up data from this snapshot. After you perform a backup the snapshot is
removed.
Note:
applies only to a single volume. If your application stores data in two or more volumes,
the snapshot backup will not provide a consistent point-in-time copy of the files.
snapshot in terms of the percentage of the original volume's space. Set the
value between 10 and 100 percent. The default value is 10.
for the backup session. Your choices are:
— Backup without Snapshot (default).
— Backup with Failsafe Snapshot. Uses the snapshot method, but if the
snapshot fails, the backup continues without a snapshot.
— Backup with Snapshot. Uses a snapshot during the backup. If you select
this option, be sure the snapshot volume percentage field is large enough
to accommodate the snapshot for the backup.
You can not performing incremental NDMP backups with snapshots. If you need
NDMP creates a snapshot for each file volume. Therefore, a point-in-time copy
Configuring Your System and Network
91