Assigning Ip Addresses; Firmware Upgrades; Standard Server Upgrades - HP StorageWorks 8000 - NAS User Manual

HP NAS 8000 System and Hardware Upgrades

Assigning IP Addresses

After you have installed NICs, you must assign IP addresses.
1. In Command View NAS, click the Configuration tab.
2. Navigate to Networking Settings > TCP/IP and select IP Addresses. Your
3. Enter the IP address for the new NICs in the address location field.
For more information, see

Firmware Upgrades

Upgrading the firmware of the NAS server requires attaching a keyboard and
monitor. See the following support site to acquire the necessary disk images and
upgrade instructions:

Standard Server Upgrades

Additional standard upgrades may be made to the NAS server. These upgrades do
not require any additional configuration of the NAS 8000 solution. Please contact
your HP support representative for information regarding supported server
configurations.
For additional upgrade information, see:
216
current NIC configuration is displayed.
http://www.hp.com/support/nas8000
Firmware upgrades
Accessories and upgrades
http://www.hp.com/support/nas8000
Replaceable parts
Defining IP Addresses
http://www.hp.com/support/nas8000
on page 63.