Canon MultiPASS C755 Service Manual page 35

MultiPASS C755 Chapter 2: Assembly and Disassembly
Disassembly 2. Scanning assembly
(1) Perform disassembly 1.
(2) Remove the three cables (e), connected to the SCNT board at the left side of the main unit. Also, remove
the cables (f), connecting the SCNT board and the PCNT board. Then, remove the two cables (j), from
the carriage motor and the ink sensor, and remove the cable guide (c). When you remove the cable
guide, prise loose the tabs (d).
(3) Remove the two screws (g).
(4) Remove the two screws (a), and then take off the ground plate (b).
(5) Remove the stopper (h), and then remove the control panel and ADF upper assembly.
(6) Remove the two screws (i), and remove the ADF lower assembly.
c
D
e
C
h
g
e
A
B
d
E
D
C
Figure 2-6 Disassembly 2
e
g
B
1
i
A
a
j
2-8
a
b
f
E