Display Assembly - HP 8710p - Compaq Business Notebook Maintenance And Service Manual

Display assembly

NOTE: All display assembly spare part kits include 3 WLAN antenna transceivers and cables.
Description
17.0-inch, WUXGA+ WVA AntiGlare display assembly
17.0-inch, WSXGA+ WVA AntiGlare display assembly
17.0-inch, WSXGA+ WVA BrightView display assembly
17.0-inch, WXGA+ AntiGlare display assembly
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
6. Remove the switch cover (see
Remove the display assembly:
1. Turn the computer upside down, with the rear panel toward you.
2. Remove the two Torx T8M2.5×9.0 screws (1) from the rear panel that secure the display assembly
to the computer.
3. Remove the three Torx T8M2.5×9.0 screws (2) from the base enclosure that secure the display
assembly to the computer.
4. Turn the computer right-side up, with the front toward you.
Battery on page 44).
Keyboard on page 60).
Switch cover on page 67).
Component replacement procedures
Spare part number
450582-001
450580-001
450581-001
450583-001
77