Expansion Memory Module - HP 8710p - Compaq Business Notebook Maintenance And Service Manual

Expansion memory module

Description
4096-MB (PC2-5300, 667-MHz, DDR2)
2048-MB (PC2-5300, 667-MHz, DDR2)
1024-MB (PC2-5300, 667-MHz, DDR2)
512-MB (PC2-5300, 667-MHz, DDR2)
Before removing the expansion memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
Remove the expansion memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
2. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
memory module slot.
Reverse this procedure to install the expansion memory module.
Battery on page
Keyboard on page
Memory modules are designed with a notch (3) to prevent incorrect installation into the
44).
60).
Component replacement procedures
Spare part number
469650-001
450576-001
450575-001
450577-001
63