Advertisement
11. Lift
motor
and insert the TWO PINS on motor base
into HOLES in cradle ... push motor in as far as it will
go.
12. Lower the blade...install
belt on saw pulley and motor
pulley,
13. Sight along edges- of both
pulleys and move motor
pulley so that
belt is parallel to the edges of both
pulleys...tighten
the setscrew in the motor pulley.
14. IMPORTANT:
Measure the distance from end of motor
shaft to pulley...mark
this dimension
down; you will
need it later when reinstalling the pulley.
15. Make sure blade is g0 ° to table . . .raise i_all the way
up.
16. Lift motor until edge of washer is even with end of slot
...
tighten pivot screw, In this position,
pull motor
toward you (pins will slide out of cradle) until belt is
TIGHT
...
tighten the two MOTOR
BASE CLAMP
SOREWS.
17. Loosen Pivot Screw slightly.
18. Lower the saw blade all the way down.
19. IMPORTANT:
Motor should pivot freely downward
as
blade is lowered,
If it does not, LOOSEN the PIVOT
SCREW some more.
20. Pivot screw must be adjusted only tight enough to allow
motor
to pivot FREELY
as blade is raised or lowered.
This will maintain constant tension on belt.
EDGE OF WASHEF
EVEN WITH END
OF SLOT
PIVOT SCREW
MOTOR PULLEY
"_
BASE
CLAMP SCREWS _
21. Loosen
the two
MOTOR
CLAMP
SCREWS
on each end
of motor.
Rotate
the motor
so that the CAPACITOR
COVER
is on top,..tighten
the screws. The ventilation
holes are now
facing downward
which
will help prevent
sawdust
from
entering
motor.
CAPACITO_
COVER
\
VENTILATION
HOLES
MOTOR
CLAMP
SCREW
• (BOTH ENDS)
17
Advertisement
