Advertisement
9. Holdrodwithonehand andwitha7/16(n.wrench o r
pliers start s crewing onONE of thenuts onlyATURN
OR TWO... screw onother n utthesame w ay.
10.Using T WO 7/16in.wrenches or pliers tighten both of
thenuts.
11. Slide the bars so that screws are in the MIDDLE
of the
slotted holes.
12. Position rip fence over miter gauge groove, holding up
the rear end while engaging front end with bar ...
lower fence onto table.
13. Raise blade all the way up.
14. Carefully move fence against blade.
15. Move
front
bar until
"0"
mark on
rip scale is
approximately at tip of pointer.
16, Move FRONT
bar upwards until fence is approximately
1/32 in. above table
...
tighten
screw at left end of
bar.
NOTE;
Fold a piece of newspaper making 8 thicknesses
and place between rip fence and table to act as a spacer.
This will hold the fence off of the table approx. 1/32
In.
17. Adjust rear bar so that the fence is approximately
1/32
'n. above table make sure it is square with fence guide
bar rod ...
tighten screw at end of bar.
18. Replace screws in rear of table extension
..,
be sure
top surface of extension
is PARALLEL
to top surface
of rear guide bar.
8 THICKNESSES
PAPF.,R
\
\
19. Move fence to RIGHT edge of table ...
make sure it is
approx. 1/32
in. above table at front and rear and
tighten screws,
11
Advertisement
