Advertisement
Lay REAR
FENCE
GUIDE
BAR on table to act as a
straightedge. If outer edge of extension
is higher or lower
than table surface;
A. Slightly loosen nuts holding bracket to extension
using 7/16 in. wrench.
B. Move end of extension up or down until outer edge
is even with table surface ...
check with GUIDE
BAR ... tighten nuts.
C,
Recheck INNER edge of extension to make sure it
has not moved ...
readjust, if necessary,
INSTALLING
RIP FENCE GUIDE BARS
I.
From
among the
loose parts
find the
following
hardware:
2 Hex. Head Screws, 5/16 in. - 18 x 1-1/2 in. long
2 Hex. Head Screws, 5/16 in. - 18 x 1 in. long
4 Hex. Nuts, 5/16 in. - 18 (approx, dia. of hole 5/16
in.)
4 External Lockwashers, 5/16 in. (approx. dia. of hole
5/16 in.)
2 Spacers, 3/4 in. dia. x I/2 in. long
2 Self-threading nuts
2. Lay guide bars on table.
NOTE: The various holes in the bars allow them to be
repositioned on the saw and also makes them adaptable
to other models.
3.
Insert 1-1/2 in. long screw through the THIRD
hole
from the LEFT
IN THE
FRONT
BAR
...
insert
another 1-1/2 in. long screw through LARGE
hole in
SWITCH
BRACKET
then through SEVENTH
hole in
bar. Hold them in place with
a piece of masking tape
from the underside.
4. Place spacerson screws.
Insert bolts through holes in middle and on right side of
front
of saw table ...
instal
Iockwashers and nuts.
DON'T
SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
6.
Remove the 3 screws from rear of table extension.
7. Insert 1 in. long screws in SECOND and FOURTH
holes
of rear bar and attach to tabSe the same way.
8.
Insert ends of FENCE
GUIDE
BAR
ROD through
round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded
... the
SELF THREADING
NUTS will cut threads on the rod
as they are screwed on.
]0
Advertisement
