Advertisement
WARNING:
Always wearsafetygoggles orsafetyglasses with
sideshields whenoperating tools.Failure to doso
couldresult i nobjectsbeingthrown intoyoureyes,
resulting
in possible serious injury
WARNING:
Do not allow familiarity with your drill-driver to make
you careless
Remember that a careless fraction of a
second is sufficient to inflict severe injury
CHARGING
YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems_
Therefore, you should charge it until light on front of
charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged
Mow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
m Charge battery pack only with the charger
provided.
[] Make sure power supply
is normal
house
voltage,
t20 volts, 60 Hz, AC only.
[] Connect charger to power supply.
[] Place battery pack in charger aligning raised rib in
charger with groove in battery pack.
[] Press down on battery pack to be sure contacts on
battery pack engage properly with charger
contacts.
[] Red light should turn on. Red light indicates fast
charging mode.
if red light is flashing, this indicates battery pack is
deeply discharged or hot.
If battery pack is hot, red light should become
steady after battery pack has cooled down
If battery pack is deeply discharged,
red light should
become steady after voltage has increased,
normally within 30 minutes.
If after one hour red light is still flashing, this
indicates a defective battery pack and should be
replaced
Green light on indicates battery pack is in slow
charging mode or fully charged
Yellow light on and red light flashing indicates
defective battery pack. Return battery pack to your
nearest Sears Repair Center for checking or
replacing.
[] When your battery pack becomes fully charged, the red
lightwill turn OFF and the green light will turn ON
Im If you remove battery pack from charger
and
reinsert
it immediately
(less than 5 seconds)
back in charger, the green light will come on
indicating
full charge and slow charging
mode
until removed from charger. If you remove
battery pack from charger
and wait more than 5
seconds
before reinserting
it back in charger,
the charger will function
normally.
[] After normal usage, 1 hour of charging time is required to
be fully charged_A minimum charge time of 1-1/2 hours
is required to recharge a completely discharged tool.
[] The battery pack witl become slightly warm to the touch
while charging. This is normal and does not indicate a
problem..
[] DO NOT place charger in an area of extreme heat
or cold It will work best at normal room
temperature,
,_
CAUTION:
Your drill-driver's battery pack contains special high
temperature
batteries to help prevent battery damage
when left on charge for extended periods of time,
However, once the batteries become fully charged, we
recommend that you unplug your charger from power
supply and disconnect it from the battery pack.
=
,= H H,
=
,= H=HH=='H==NI'11==
H "
=="N'I'
LED FUNCTION
OF CHARGER
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
1.
Red LED Lighted = Fast Charging Mode°
2.
Green LED Lighted = Slow Charging Mode and Fully Charged Battery Pack.
3
Red LED Flashing = Hot or Deeply Discharged
Battery Pack. Also Defective
Battery Pack After 1 Hour_
4
Yellow LED Lighted and Red LED Flashing = Defective Battery Pack.
................................
HHil_r
H,,=l,,
Page 7
Advertisement
