Advertisement
RULES
FOR SAFE OPERATION
(Continued)
[]
An extension cord should not be used unless
absolutely necessary
Use of improper
extension cord could result in a risk of fire and
electric shock
If extension cord must be used,
make sure:
a
That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b
That extension cord is properly wired and in
good electrical condition; and
c.
That wire size is farge enough for AC
ampere rating of charger as specified
below:
AWG Size of Cord/Length of Cord, Feet
Feet
25
50
100
150
AWG
16
16
16
14
[]
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG° If damaged,
have replaced immediately by a qualified
serviceman
[]
Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
serviceman
[]
Do not disassemble charger; take it to a
qualified serviceman when service or repair is
required
Incorrect reassembly may result in a
risk of electric shock or fire
[]
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning
Turning off controls will not reduce
this risk_
[]
Do not use charger outdoors.
[]
Disconnect charger from power supply when
not in use
N
SAVE THESE INSTRUCTIONS_ Refer to them
frequently and use them to instruct others who
may use this tool. If you loan someone this tool,
Ioan them these instructions also..
,_
Look for this symbol
to point
out important
safety
precautions.
It means
attention!H
Your
safety
is involved.
in=
,n,miu,u=,,
= 11 =u,,u,, =,u,n,u
= u,H=,l
IMPORTANT
INFORMATION
FOR
When using your drill-driver continuously,
the batter-
ies in your battery pack will become hot You should
let a hot battery pack cool down for approximately
30
minutes before attempting to recharge.
Note: This situation only occurs when continuous use
of your drill causes the batteries to become hot It
RECHARGING
HOT BATTERIES
does not occur under normal circumstances
Refer to
"CHARGING
YOUR DRILL-DRIVER"
for normal
recharging of batteries. If the charger does not charge
your battery pack under normal circumstances,
return
both the battery pack and charger to your nearest
Sears repair center for eEectrica! check.
._
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.
Page 5
Advertisement
