Led Worklight; Fuel Gauge - Craftsman NEXTEC 320.30565 Operator's Manual

For delicate operations, such as removing a partially stripped screw, use a
low torque setting. For operations such as drilling into hardwood, use a higher
torque setting.
NOTICE: When adjusting the I
torque clutch make sure that I Fig. 7
the speed switch is either com-
pletely in the LO or HI Position.
CAUTION: Do not change
the torque setting when the tool
is running.
DRILL MODE (Fig. 7)
Select the drill mode for drilling and
other heavy duty applications.
To select Drill mode, rotate the
torque-adjustment ring until the
icon aligns with the torque indi-
cator and clicks into position.
LED WORKLIGHT (Fig. 8)
The LED worklight, located
on the base of the drill/driver,
will illuminate when the trig-
ger switch is depressed. This
provides additional light on the
surface of the workpiece for
operation in lower-light areas.
The LED worklight will turn off
when the trigger switch
is released.
Drill icon Torque indicator
FUELGAUGE (Fig. 9)
This tool is equipped with a
FuelGauge, which indicates the
battery-pack charge level.
The green LED on the Fuel-
Gauge indicates that the bat-
tery is fully charged.
The orange LED on the Fuel-
Gauge indicates that the bat-
tery has used approximately
one half of its charge.
The red LED on the Fuel-
Gauge indicates that the
battery pack is depleted and
needs to be charged.
Fig. 9
FuelGauge
1
30565 ManuaLRevised_11-0616 Page 17