Epson TM-FX2180 Service Manual page 59

EPSON FX-2180 Service Manual
Disconnect the cables from the following connectors on the main
5.
board assembly.
Table 4-6. Main Board Connectors
Connector Pins Connector
Number Color
CN4 3 white
CN6 2 white
CN8 18 gray
CN10 4 white
CN12 4 white
Note: To disconnect the cables from CN10 and CN11, pull up the
connector locks.
As shown in Figure 4-20, remove the four printer mechanism
6.
mounting screws securing the printer mechanism.
Remove the printer mechanism.
7.
T
IMPORTANT
When you connect the cables to CN10 and
CN11, align the red line in the cable with pin 1
of the connector.
T
The tightening torque for the four printer
mechanism mounting screws is 0.78 - 0.98 Nm
(10 - 12 Kgf-cm).
Adjust the bidirectional print alignment and reset
the TPE level. (See Chapter 5.)
Connector Pins Connector
Number Color
CN5 3 black
CN7 4 gray
CN9 16 gray
CN11 5 white
CN13 4 black
Chapter 4 Disassembly and Assembly
printer mechanism mounting screws
Figure 4-20. Removing the Printer Mechanism
4-14