Leds - Epson TM-FX2180 Service Manual

EPSON FX-2180 Service Manual
Table 1-15. Button Functions
Button
Operate Turns the printer on and off. The printer is off when the top
of this button is even with the button protectors.
Pause Stops printing temporarily, and resumes printing when
pressed again. (Selects on line or off line status.)
When held down for three seconds when the printer is in
the standby state, enters the micro adjust mode. When
pressed again, exits the micro adjust mode.
Load/Eject Loads continuous paper from the standby position.
Feeds continuous paper backward to the standby
position.
Loads a single sheet of paper from the paper entry slot.
Ejects a single sheet of paper if a sheet is loaded.
LF/FF When pressed, executes a line feed.
When held down, executes a form feed. This advances
continuous paper to the next top-of-form position or
ejects a single sheet.
Tear Feeds continuous paper forward to the tear-off position.
Off/Bin Feeds continuous paper backward from the tear-off
position to the top-of-form position.
Selects a cut-sheet feeder bin when the cut-sheet feeder
is installed.
Enters the card mode to print on postcards and
envelopes.
Font Selects one of the following fonts: Draft, Roman, or Sans
Serif.
Pitch Selects one of the following font widths: 10 cpi,
12 cpi, 15 cpi, 17 cpi, 20 cpi, or PS (proportional spacing).
Micro In the micro adjust mode, executes a micro feed (moves
Adjust / the paper forward or backward 1/216 inch). Depending on
the position of your paper, you can use this button to adjust
the top-of-form or tear-off position.
Function

1.2.1.2 LEDs

Table 1-16. LED Indicators
LED(s) Color
Pause Orange
Paper Out Red
Tear Off/Bin Green
Font Green Indicates which font is selected.
Pitch Green Indicates which font size is selected.
Chapter 1 Product Description
Description
On when the printer is paused.
Off when the printer is on line.
Flashes when the printer is in the micro
adjust mode or the print head is
overheated.
On when no paper is loaded or paper is
not loaded correctly in the selected paper
source.
Off when paper is loaded correctly in the
selected paper source.
Flashes when paper has not been fully
ejected or a paper jam has occurred.
o o when continuous paper is not in the
tear-off position.
f f when continuous paper is in the tear-
off position.
o n when bin 1 of the optional cut-sheet
feeder is selected.
n o when bin 2 of the optional cut-sheet
feeder is selected.
n n when the printer is in the card mode.
n = on o = off f = flashing
1-11