Advertisement
For your safety, turn switch OFF, and remove the power
cord from the electrical outlet before adjusting, cleaning, or
performing maintenance on your sander.
To avoid electric shock or fire, all repairs to the electrical
components should be done by qualified service
technicians.
Before each use check for damaged, missing, or worn
parts; check for alignment of moving parts, binding,
improper mounting, or any other conditions that may
affect the operation. Should any oFthese conditions exist,
do not use the sander until properly repaired or parts are
replaced. Frequently blow or vacuum dust from alf sander
parts and motor housing.
After sanding wood or non-metallic material, always clean
the sawdust from sander or work area before grinding or
sharpening metal workpieces. Sparks could ignite and
cause a fire.
LUBRICATION
Ball bearings are grease packed at the factory and
require no further lubrication. Use a spray lubricant to
ensure smooth operation on all moving table parts.
TROUBLESHOOTMNG
GUIDE
Turn switch OFF and always remove plug from power source before making any adjustments or repairs,
All electrical or mechanical repairs, should be done only by qualified service technicians. Contact the nearest Sears
Service Center.
PROBABLE
CAUSE
1. Defective or broken ON/OFF switch.
2. Defective or damaged switch cord.
3. Defective
or damaged switch relay.
4. Burned out motor,
PROBLEM
Motor will not run.
Machine stows down
while sanding.
,,,,,,,,,,,
Sanding belt runs off pulleys.
Wood burns while sanding.
Motor overheats.
5. Blown house fuse.
1. Operator applying too much
pressure to workpiece,
2. Dirt on wheels.
3. Worn or stretched belt.
1. Not tracking properly.
,
2.
Sanding disc or belt glazed with sap.
Excessive pressure being applied
to workpiece.
1. Motor overload.
REMEDY
1-3, Replace all broken or defective
parts before using sander.
4.
Consult your local Sears Service
Center, Any attempt to repair this
motor may create a hazard unless
repair is done by a qualified
technician.
5.
Replace house fuse. Turn OFF
other appliances and power tools
on the same circuit.
I.
Use less pressure in applying
workpiece to sanding surface.
2.
Clean wheels.
3.
Replace pulley belt.
1.
Adjust tracking. See section
"TRACKING".
I.
Replace belt or disc.
2.
Reduce pressure applied to
workpiece.
1.
Reduce motor load. Allow
to coot off before restarting.
16': :::::
::::::::: ::::: : : : ::
::: :
:: : :: :
:
:=,i
t7
::: ::::::
:::::::::
:: :: ::::::::::::::::::::::::
::::: ::::::::::::::::::::
Advertisement
