Advertisement
Belt tracking bolt
Rotation arrow
Miter
gauge
Rotation arrow
Disc guard
Nameplate
g belt
Belt backstop
Belt guard
Belt guard
knob
Dust chute
Tilt index
Disc table
locking handle
Belt housing
Motor
Power cord
Belt table
Mounting hole
Base
d
Disc guarlng disc
Disc table
_o
.__
"--'------
- Titt index
_
--_-_--"-_
Disc table locking handle
_
Dust chute
8
ASSEMBLY
NSTRUCTmONS
For your own safety, never connect plug to power source
outlet until al! assembly and adjustment steps are
completed, and you have read and understood the safety
and operating
instructions,
Phillips screwdriver
Combination square
Hex keys 10ram (3, 4, and 6 mm included)
This belt / disc sander requires minimal assembly.
When replacing abrasive disc or abrasive belt, or any parts
on the sander, turn switch OFF and remove the
plug from the power source.
INSTALLING 1 REPLACING 2" X 42" BELT
(FIG, A)
1.
Tilt the table (1) out of the way.
2.
Remove the belt guard (2) by removing the two belt
guard knobs (3).
3.
Release the belt tension by SLIGHTLY moving and
holding the tension handle (4) down.
4.
Remove the abrasive belt (5),
5.
Install and align the new abrasive belt on the lower
wheel (6), the back wheel (7), and on the top wheel
(8). There is an arrow on the inside of the belt, To avoid
belt damage, this arrow must point in the same
direction as the rotation arrow on the belt housing.
6.
Release the belt tension handle (4). Spring action wilt
tension the belt when the handle is released.
7.
Make sure the belt is tracking correctly, and adjust if
necessary. When the beft is tracking properly it rides
on the center of each wheel (see "TRACKING THE
BELT"),
8.
Replace the belt guard,(2) and the belt table (1).
NOTE: The belt rotates
counterclockwise.
When
installing
a belt, make sure the arrow
points
in the same
direction
as the rotation
arrow on the top of the belt guard
housing,
down toward
the front bett table.
Fig. A
INSTALLING BELTTABLE
(FIG. B)
t
Place the slot (5) of the belt table bracket
on to
the lug (6} on the left side of the belt housing.
2,
Place
the
handle
(3)
onto the
hole (6), Press
buttom
(4), screw(7)
and tighten.
3.
Be sure the gap between belt and table is 1/I6".
Turn the handle to lock the table.
Fig. B
/_
6
3
7
9
D
Advertisement
