Craftsman 351.217520 Operator's Manual page 4

Figure 1 - Unpacking
• Re-install tailstock assembly onto the bed in the same
manner as the tool rest base. Secure in position with
locking lever.
• Place tool rest into tool rest base and secure in position
with locking handle.
Tool Rest
ig
Handle
Refer to Figures 2 - 8.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
• Remove all components from the shipping carton and verify
against the parts list on page 3. Clean each component and
remove shipping preservatives (coatings) as required. Do
not discard packing material and shipping carton until lathe
has been set up and is running properly.
• After selecting an appropriate bench, table, or lathe stand,
set the bed towards the front and the left side.
• Remove the tailstock assembly from lathe bed. Release
locking lever and slide tailstock off lathe bed.
Figure 4 - Install Tool Rest
• Thread index pin assembly onto head completely using an
adjustable wrench.
WARNING: Index pin must be disengaged in up position
before turning lathe on.
I Index Pin
Assembly
Figure 2
Slide the tool rest base assembly onto the bed. Make
sure clamping plate is oriented with slot in bed. Secure
the position with locking lever. To adjust the clamping plate
action, adjust locking nut clockwise to tighten and counter-
clockwise to loosen.
Lock Nut
Figure 3 - Bottom View of Tool Rest Base
Locking
Lever
Figure 5 - Install Index Pin
• Insert spur center into headstock spindle. Slide center into
spindle with a firm, swift movement. Center will be further
secured when a workpiece is mounted between centers.
Spur Center
Figure 6
4