Start The Engine; Tow Truck - Chery V5 User Manual

4. Connect one terminal of wire B
to the negative (-) terminal of the
support battery, the other terminal
to the metal part of the engine to
be started. Position the jumper
wire in order to avoid it contacts
the motion parts in the engine
compartment.
DO NOT connect to the
negative (-) terminal of the
low power battery.
5. Make sure that the jumper cable
can't interfere with the motion
parts of engine.

Start the engine

1. The engine of vehicle equipped
with the support battery operates
at the proper high speed.
2. Start the engine of vehicle with
To reduce the voltage surge
during removal, please turn
on the blower and electric
heating type rear windscreen of the
vehicle with low power battery.
Please DO NOT turn on the headlamp
to substitute the electric heating type
rear windscreen, otherwise the surge
voltage may burn out the bulb.
the low power battery, and start
the vehicle with the low power
battery within one
A.S.A.P.
3. Let the two engines of vehicles
operate for three seconds before
the down-lead is removed.
Remove the down-lead
Remove the down-lead B(-), and
then the down-lead A (+).
Emergency Procedures

Tow truck

There are trunk rings equipped at the
front and rear of the vehicle in order to
install the tow cable.
During towing, slowly and smoothly
travel to avoid the tow truck bounces.
The big tow force may damage the
vehicle.
second
During towing, the ignition
switch of the vehicle to be
towed shall be placed on the
"ON" position to make the steering
wheel, turn signal lamp and stop lamp
work. Since the engine extinguishes,
there is no brake boost and steering
boost. The required operating force
need to be increased. So, the power of
brake and
corresponding increases.
steering shall
141