Table of Contents
Advertisement
4.
Tell the passengers to leave the
vehicle.
5.
If necessary, use the proper wheel
stopper to secure the vehicle in
order to avoid the roll or slide.
6.
Insert the flat head screwdriver
into the gap between the steel
ring and hub cap, and carefully
turn it to remove the hub cap.
7.
As shown in the figure below, use
the special tool to unscrew the
wheel nuts.
8.
Place the jack, and ensure that the
whole seat is located on a solid
ground.
9.
The jack must vertically lift up to
the jack lift point.
10.
Lift up the vehicle until the wheel
departures from the ground.
11.
Remove the wheel nuts and then
take out the wheel.
Emergency Procedures
Install the wheel
1.
Push the wheel to the rim bolt,
tighten the wheel nut in the
clockwise direction and make
sure that the tip of wheel nut
faces to the wheel.
2.
Lower the vehicle and remove
the jack.
3.
Utilize the diagonal tightening
method to fully tighten wheel
nuts (the tightening torque is
110±10 Nm).
4.
Steadily press the hub cap by
your both hands.
5.
Collect the jack and fault wheel,
in the reverse order and fasten
them.
6.
Do best to send them to the
137
Advertisement
Table of Contents
