Bosch Nexxt washer Operating, Care And Installation Instructions Manual page 34

Fault
Washing solution has not
drained completely,
"Drainage blocked?" indi-
cated in the display field,
'Wateris flowing out from
underneath the machine.
Suds coming out of the
detergent dispenser.
Repeatedspinning.
Thelaundrywas not
spun.
Program duration ex-
tended.
Unsatisfactory washing
result.
Detergent residue on the
laundry.
Gray residue on the
laundry.
Possible cause
The water drainage pipe and/or drain hose is
blocked.
The thread of the supply hose is not tight.
Leak in the drain hose.
Too much detergent.
This is not a fault.
The imbalance compensation system is attempting to
baiancethe toadthrough repeated spins.
Large items of clothing have become entangledand
could not be distributed evenly in the drum. For rea-
sons of safety the high-speed spin cycle was auto-
maticaiiy suppressed.
This is not a fault.
The suds detection feature has activated an addition-
ai rinsing cycle to reduce the amount of suds.
This is not a fault.
The imbalance compensation system is attempting to
baiancethe toadthrough repeated spins.
The degree of soiling was higher than estimated.
Not enough detergent.
Some phosphate-free detergents contain water-insoI-
ubie residues that may appear as light spots on the
laundry,
Dirt accumulation from ointments, fats or oils.
Action
Cleanthe water drainage pipe and/or drain hose.
Tighten the thread.
Reptacethe drain hose.
Mix 1 tablespoon of fabric softener with 1 pt ('Z, litre)
of water and pour into detergent dispenser I.
Reduce the amount of detergent next time, use a low
sudsing detergent.
Always load the drum with large and small items
together.
Always load the drum with large and small items
together.
Add a more appropriate amount of detergent.
Always load the drum with large and small items
together.
Setect suitable program
or
Power Wash as an additional option.
Add detergent according to the manufacturer's
specifications.
Brush off spots when laundry is dry.
Add the maximum amount of detergent and select
the highest permissible temperature.
Fault displays
Text in display Possible cause Action
field
"Watertap closed?" Water taps not turned on,
Supply hose kinked or trapped,
Strainer in supply hose ctogged.
Water pressure too low.
The water drainage pipe and/or drain hose is biocked,
Door not closed property.
"Drainage blocked?"
"Check Door!"
Turn on water tap. Program continues.
Eliminate the cause.
Cleanthe water inlet strainers; see Page 30.
Eliminate the cause.
Cleanthe water drainage pipe and/or drain hose.
Check whether laundry is trapped in door.
Close the door.
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the
appliance on again, select and start the program.
If the fault continues, call customer service; see Page 35.
34